Carbide buttons It has a refined finish with excellent size and style for better quality. The replacement of the button requires items like a torch, heating methods of about 1500F.
Remove old buttons
You heat the old carbide tooth with light and afterward, you flick or push the old tooth off. The old carbide tooth will ordinarily not tumble off all alone. People, to retip sawblades, utilize sort of a sharp, flicking movement to thump the old tooth off. There is a video on eliminating the old carbide tip underneath.
Prepare new buttons before you mount
When you are supplanting carbide teeth, you should simply put the new tooth, braze compound side down, in a similar spot the old tooth was. The new braze composite will blend in with the old braze amalgam fine and dandy.
If you are putting stump processor teeth on your stump processor unexpectedly then you need to ensure that your steel is liberated from scale or rust just as liberated from oils or oils. Simply cleaning the steel off could conceivably work.
Begin the process of heating
The carbide button steel will extend around a few fold the amount of as the carbide so warming through the carbide levels this out. On the off chance that you get the steel above 1500° F, the steel will get fragile so you truly need to warm through the carbide.
READ ALSO: Top uses of tungsten carbide that you should know
As you heat, three things will occur:
1. The water will bubble out of the brazing transition
2. Somewhat later the brazing transition will go to fluid and spread out
3. At last the braze compound will dissolve
This is the reason you need the pokey stick or document
Use Sticks
When the water bubbles out, the transition turns fluid and when the brazing compound turns fluid. The carbide tip or stump processor tooth can buoy and move a bit. Utilize the pokey stick to delicately prod the part back where you need it. Try not to push down on the part with the pokey stick or you'll extract the braze from the joint.
Use of BrazeJoint
A slight layer of brazing compound in the joint will give you more prominent elasticity. A thick layer of brazing compound in the braze joint will give you more effective insurance and padding from stun. Our pre-tinned tips have a painstakingly determined measure of brazing compound on them to give you the best mix of brazing joint strength andeffect assurance. Try not to push down on the tip. You will push all the braze compound out which squanders cash and makes a lot more fragile braze joint.
Check the final process
When you have the tooth warmed up appropriately and prodded into the spot you need it at that point delicately pull your light away while you hold the tip set up. Try not to push down on the tip, simply hold it set up.
THIS BLOG ALSO READ